D-Link xStack - Chapter 84 Protocol VLAN Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
970
Chapter 84 Protocol VLAN
Commands
create dot1v_protocol_group group_id <int 1-16> {group_name <name 32>}
config dot1v_protocol_group [group_id <int 1-16> | group_name <name 32>] [add protocol
[ethernet_2 | ieee802.3_snap | ieee802.3_llc] <protocol_value> | delete protocol [ethernet_2 |
ieee802.3_snap | ieee802.3_llc] <protocol_value>]
delete dot1v_protocol_group [group_id <int 1-16> | group_name <name 32> | all]
show dot1v_protocol_group {[group_id <int 1-16> | group_name <name 32>]}
config port dot1v ports [<portlist> | all] [add protocol_group [group_id <int 1-16> | group_name
<name 32>] [vlan <vlan_name 32> | vlanid <id>] {priority <value 0-7>} | delete protocol_group
[group_id <int 1-16> | all]]
show port dot1v {ports <portlist>}
84-1 create dot1v_protocol_group
Description
This command is used to create a protocol group for the protocol VLAN function.
Format
create dot1v_protocol_group group_id <int 1-16> {group_name <name 32>}
Parameters
group_id - Specifies the ID of the protocol group which is used to identify a set of protocols.
<int 1-16> - The ID range is between 1 and 16.
group_name - Specifies the name of the protocol group.
<name 32> - Enter the name of the protocol group. The maximum length is 32 characters.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a protocol group:
DGS-3620-28SC:admin#create dot1v_protocol_group group_id 4 group_name
General_Group
Command: create dot1v_protocol_group group_id 4 group_name General_Group
Success.
DGS-3620-28SC:admin#