D-Link xStack - Debug Vrrp

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
331
DGS-3620-28SC:admin# debug ospf state enable
Command: debug ospf state enable
Success.
DGS-3620-28SC:admin# debug ospf show flag
Command: debug ospf show flag
Global State: Enabled
Current OSPF Flags Setting:
Neighbor State Change
DGS-3620-28SC:admin#
21-30 debug vrrp
Description
This command is used to set VRRP debug flags.
Format
debug vrrp [vr_state_change | packet [all | {receiving | sending}(1)] | mac_addr_update |
interface_change | timers] state [enable | disable]
Parameters
vr_state_change - Specifies the state of the VRRP change debug flag.
packet - Specifies to set the VRRP packet flags.
all - Specifies to set VRRP all packet debug flags.
receiving - (Optional) Specifies to set the VRRP packet receiving flag.
sending - (Optional) Specifies to set the VRRP packet sending flag.
mac_addr_update - Specifies the state of VRRP MAC debug flag.
interface_change - Specifies the state of VRRP interface debug flag.
timers - Specifies the state of VRRP timer's debug flag.
state - Specifies the state of the configured VRRP debug flag.
enable - Specifies that the configured VRRP debug flag will be enabled.
disable - Specifies that the configured VRRP debug flag will be disabled.
Restrictions
Only Administrator level users can issue this command.
Example
To enable the VRRP virtual router state change debug flag: