D-Link xStack - Enable Telnet; Disable Telnet

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
21
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable pausing of the screen display when show command output reaches the end of the page:
DGS-3620-28SC:admin#disable clipaging
Command: disable clipaging
Success.
DGS-3620-28SC:admin#
2-16 enable telnet
Description
This command is used to enable Telnet and configure a port number. The default setting is
enabled and the port number is 23.
Format
enable telnet {<tcp_port_number 1-65535>}
Parameters
<tcp_port_number 1-65535> - (Optional) Specify the TCP port number. TCP ports are
numbered between 1 and 65535. The “well-known” TCP port for the Telnet protocol is 23.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable Telnet and configure a port number:
DGS-3620-28SC:admin#enable telnet 23
Command: enable telnet 23
Success.
DGS-3620-28SC:admin#
2-17 disable telnet
Description
This command is used to disable Telnet.