D-Link xStack - Show Sntp

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1132
Success.
DGS-3620-28SC:admin#
106-2 config sntp ipv6server
Description
This command is used to configure the SNTP IPv6 server information.
Format
config sntp ipv6server {primary <ipv6addr> | secondary <ipv6addr> }(1)
Parameters
primary - SNTP primary IPv6 server address.
<ipv6addr> - Enter the IPv6 address of the Primary SNTP IPv6 server.
secondary - SNTP secondary IPv6 server address.
<ipv6addr> - Enter the IPv6 address of the Secondary SNTP IPv6 server.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure SNTP (primary IPv6 server: 1000::1, secondary IPv6 server: 1000::2):
DES-3620-28SC:admin#config sntp ipv6server primary 1000::1 secondary 1000::2
Command: config sntp ipv6server primary 1000::1 secondary 1000::2
Success.
DES-3620-28SC:admin#
106-3 show sntp
Description
This command is used to display the current SNTP time source and configuration.
Format
show sntp
Parameters
None.