D-Link xStack - Enable Ospf

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
852
Example
To display the current OSPF virtual interface configuration:
DGS-3620-28SC:admin#show ospf virtual_link
Command: show ospf virtual_link
Virtual Interface Configuration
Transit Virtual Hello Dead Authentication Link
Area ID Neighbor Router Interval Interval Status
--------------- --------------- -------- -------- -------------- ------
4.4.4.4 1.1.1.1 10 60 MD5 Up
4.4.4.4 6.6.6.6 10 250 Simple Down
Total Entries : 2
DGS-3620-28SC:admin#
73-19 enable ospf
Description
This command is used to enable OSPF on the switch.
Format
enable ospf
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable OSPF on the switch:
DGS-3620-28SC:admin# enable ospf
Command: enable ospf
Success.
DGS-3620-28SC:admin#
73-20 show ospf
Description
This command is used to display the current OSPF settings on the switch.