D-Link xStack - Chapter 104 System Severity Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1126
Chapter 104 System Severity
Commands
config system_severity [trap | log | all] [emergency | alert | critical | error | warning | notice |
information | debug | <level 0-7>]
show system_severity
104-1 config system_severity
Description
This command is used to configure severity level control for the system.
Format
config system_severity [trap | log | all] [emergency | alert | critical | error | warning | notice |
information | debug | <level 0-7>]
Parameters
trap - Configure severity level control for a trap.
log - Configure severity level control for a log.
all - Configure severity level control for a trap and a log.
emergency - Specifies to configure the severity level for emergency messages.
alert - Specifies to configure the severity level for alert messages.
critical - Specifies to configure the severity level for critical messages.
error - Specifies to configure the severity level for error messages.
warning - Specifies to configure the severity level for warning messages.
notice - Specifies to configure the severity level for notice messages.
informational - Specifies to configure the severity level for informational messages.
debug - Specifies to configure the severity level for debug messages.
<level 0-7> - Enter to configure a severity level between 0 and 7.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure severity level control for information level for a trap:
DGS-3620-28SC:admin#config system_severity trap information
Command: config system_severity trap information