D-Link xStack - Chapter 93 Single IP Management Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1038
Chapter 93 Single IP
Management
Commands
enable sim
disable sim
show sim {[candidates {<candidate_id 1-100>} | members {<member_id 1-32>} | group
{commander_mac <macaddr>} | neighbor]}
reconfig [member_id <value 1-32> | exit]
config sim_group [add <candidate_id 1-100> {<password>} | delete <member_id 1-32>]
config sim [[ commander {group_name <groupname 64> } | candidate ] | dp_interval <sec 30-90>
| hold_time <sec 100-255>]
download sim_ms [firmware_from_tftp | configuration_from_tftp] <ipaddr> <path_filename>
{[members <mslist 1-32> | all]}
upload sim_ms [configuration_to_tftp | log_to_tftp] <ipaddr> <path_filename> {[members <mslist>
| all]}
93-1 enable sim
Description
This command is used to configure the single IP management on the switch as enabled.
Format
enable sim
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable single IP management:
DGS-3620-28SC:admin#enable sim
Command: enable sim
Success.
DGS-3620-28SC:admin#