D-Link xStack - Show Switch

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
15
Total Entries: 1
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
2-8 show switch
Description
This command is used to display the switch information.
Format
show switch
Parameters
None.
Restrictions
None.
Example
To display the switch information:
DGS-3620-28SC:admin#show switch
Command: show switch
Device Type : DGS-3620-28SC Gigabit Ethernet Switch
MAC Address : 00-01-02-03-04-00
IP Address : 10.90.90.90 (Manual)
VLAN Name : default
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
Boot PROM Version : Build 1.00.016
Firmware Version : Build 2.50.014
Hardware Version : B1
Firmware Type : EI
Serial Number : D1234567890
System Name :
System Location :
System Uptime : 0 days, 0 hours, 7 minutes, 13 seconds
System Contact :
Spanning Tree : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
MLD Snooping : Disabled
RIP : Disabled
RIPng : Disabled
DVMRP : Disabled