D-Link xStack - Chapter 113 VLAN Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1194
Chapter 113 VLAN Commands
create vlan <vlan_name 32> tag <vlanid 2-4094> {type [1q_vlan | private_vlan]} {advertisement}
create vlan vlanid <vidlist> {type [1q_vlan | private_vlan]} {advertisement}
delete vlan <vlan_name 32>
delete vlan vlanid <vidlist>
config vlan <vlan_name 32> {[add [tagged | untagged | forbidden] | delete] <portlist> |
advertisement [enable | disable]}(1)
config vlan vlanid <vidlist> {[add [tagged | untagged | forbidden] | delete] <portlist> |
advertisement [enable | disable] | name <vlan_name 32>}(1)
config port_vlan [<portlist> | all] {gvrp_state [enable | disable] | ingress_checking [enable |
disable] | acceptable_frame [tagged_only | admit_all] | pvid <vlanid 1-4094>}(1)
show port_vlan {<portlist>}
config gvrp [timer [join | leave | leaveall] <value 100-100000> | nni_bpdu_addr [dot1d | dot1ad]]
enable gvrp
disable gvrp
show vlan {<vlan_name 32>}
show vlan vlanid <vidlist>
show vlan ports {<portlist>}
show gvrp
config private_vlan [<vlan_name 32> | vid <vlanid 1-4094>] [add [isolated | community] | remove]
[<vlan_name 32> | vlanid <vidlist>]
show private_vlan {[<vlan_name 32> | vlanid <vidlist>]}
enable pvid auto_assign
disable pvid auto_assign
show pvid auto_assign
113-1 create vlan
Description
This command is used to create a VLAN on the switch. The VLAN ID must be always specified for
creating a VLAN.
Format
create vlan <vlan_name 32 > tag <vlanid 2-4094> {type [1q_vlan | private_vlan]}
{advertisement}
Parameters
<vlan_name 32 > - Enter the name of the VLAN to be created. The maximum length is 32
characters.
tag - Specifies the VLAN ID of the VLAN to be created.
<vlanid 2-4094> - The range is from 2 to 4094.
type - (Optional) Specify the type of VLAN to be created.
1q_vlan - Specifies the VLAN is a 802.1q VLAN.
private_vlan - Specifies the VLAN is a private VLAN.
advertisement - (Optional) Specify to allow the Switch sending out GVRP packets to outside
sources, notifying that they may join the existing VLAN.