D-Link xStack - Config Dscp Trust; Show Dscp Trust

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
989
Example
To display HOL prevention state on the switch:
DGS-3620-28SC:admin#show hol_prevention
Command: show hol_prevention
Device HOL Prevention State: Enabled
DGS-3620-28SC:admin#
85-16 config dscp trust
Description
This command is used to enable or disable the DSCP trust state on specified ports.
Format
config dscp trust [<portlist>|all] state [enable | disable]
Parameters
<portlist> - Specifies a range of ports to be displayed.
all - Specifies that the command will apply to all ports on the switch.
state - Enables/disables DSCP trust. By default, DSCP trust is disabled.
Restrictions
Only Administrator and Operator level users can issue this command.
Example
To enable DSCP trust on ports 1:1-1:8:
DGS-3620-28SC:admin#config dscp trust port 1:1-1:8 state enable
Command: config dscp trust port 1:1-1:8 state enable
Success.
DGS-3620-28SC:admin#
85-17 show dscp trust
Description
This command is used to display the DSCP trust state.
Format
show dscp trust {<portlist>}