D-Link xStack - Show Cfm Linktrace

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
256
Restrictions
None. (EI Mode Only Command)
Example
To transmit a LTM:
DGS-3620-28SC:admin#cfm linktrace 00-01-02-03-04-05 mepname mep1
Command: cfm linktrace 00-01-02-03-04-05 mepname mep1
Transaction ID: 26
Success.
DGS-3620-28SC:admin#
16-20 show cfm linktrace
Description
This command is used to display the link trace responses. The maximum linktrace responses a
device can hold is 128.
Format
show cfm linktrace [mepname <string 32> | mepid <int 1-8191> md [<string 22> | md_index
<uint 1-4294967295>] ma [<string 22> | ma_index <uint 1-4294967295>]] {trans_id <uint>}
Parameters
mepname - Specifies the MEP name.
<string 32> - Enter the MEP name. The maximum length is 32 characters.
mepid - (Optional) Specify the MEPID.
<int 1-8191> - Enter the MEP MEPID between 1 and 8191.
md - (Optional) Specify the maintenance domain name.
<string 22> - Enter the maintenance domain name. The maximum length is 22 characters.
md_index - Specifies the maintenance domain index.
<uint 1-4294967295> - Enter the maintenance domain index value here. This value
must be between 1 and 4294967295.
ma - (Optional) Specify the maintenance association name.
<string 22> - Enter the maintenance association name. The maximum length is 22
characters.
ma_index - Specifies the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must be between 1 and 4294967295.
trans_id - (Optional) The identifier of the transaction to be displayed.
<uint> - The identifier of the transaction to be displayed.
Restrictions
None. (EI Mode Only Command)
Example
To display a CFM linktrace reply: