D-Link xStack - Chapter 41 Internet Group Management Protocol (IGMP) Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
517
Chapter 41 Internet Group
Management Protocol
(IGMP) Commands
config igmp [ipif <ipif_name 12> | all] {version <value 1-3> | query_interval <sec 1-31744> |
max_response_time <sec 1-25> | robustness_variable <value 1-7> |
last_member_query_interval <value 1-25> | state [enable | disable]} (1)
show igmp {ipif <ipif_name 12>}
show igmp group {group <group> | ipif <ipif_name 12>}
config igmp check_subscriber_source_network [ipif <ipif_name 12> | all] [enable | disable]
show igmp check_subscriber_source_network {ipif <ipif_name 12>}
create igmp static_group ipif <ipif_name 12> group <ipaddr>
delete igmp static_group ipif <ipif_name 12> [group <ipaddr> | all]
show igmp static_group {ipif <ipif_name 12>}
41-1 config igmp
Description
This command is used to configure IGMP on the Switch.
Format
config igmp [ipif <ipif_name 12> | all] {version <value 1-3> | query_interval <sec 1-31744> |
max_response_time <sec 1-25> | robustness_variable <value 1-7> |
last_member_query_interval <value 1-25> | state [enable | disable]} (1)
Parameters
ipif - Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can
be up to 12 characters long.
all - Specifies that all the IP interfaces will be used.
version - (Optional) Specifies the IGMP version used.
<value 1-3> - Enter the IGMP version number used here. This value must be between 1 and
3. The default value is 3.
query_interval - (Optional) Specifies the time in seconds between general query transmissions.
<sec 1-31744> - Enter the query interval time here. This value must be between 1 and 31744
seconds. The default value is 125.
max_response_time - (Optional) Specifies the maximum time in seconds to wait for reports from
members.
<sec 1-25> - Enter the maximum response time here. This value must be between 1 and 25
seconds. The default value is 10.
robustness_variable - (Optional) Specifies the permitted packet loss that guarantees IGMP.
<value 1-7> - Enter the robustness variable here. This value must be between 1 and 7. The
default value is 2.
last_member_query_interval - (Optional) Specifies the maximum Response Time inserted into
the Group-Specific Queries that are sent in response to Leave Group messages, which is also
the amount of time between Group-Specific Query messages.