D-Link xStack - Page 521

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
516
Command: config gratuitous_arp send periodically ipif System interval 5
Success.
DGS-3620-28SC:admin#
40-7 show gratuitous_arp
Description
This command is used to display gratuitous ARP configuration.
Format
show gratuitous_arp {ipif <ipif_name 12>}
Parameters
ipif - (Optional) The interface name of the L3 interface.
<ipif_name 12> - Enter the interface name. The maximum length is 12 characters.
Restrictions
None.
Example
To display the gratuitous ARP configuration:
DGS-3620-28SC:admin#show gratuitous_arp
Command: show gratuitous_arp
Send on IPIF Status Up : Disabled
Send on Duplicate IP Detected : Disabled
Gratuitous ARP Learning : Disabled
IP Interface Name : System
Gratuitous ARP Trap : Disabled
Gratuitous ARP Log : Enabled
Gratuitous ARP Periodical Send Interval : 0
Total Entries: 1
DGS-3620-28SC:admin#