D-Link xStack - Show Authentication

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
297
then pass.
dot1x_impb - Dot1x will be verified first, and then IMPB will be verified. Both authentications
need to be passed.
impb_jwac - JWAC will be verified first, and then IMPB will be verified. Both authentications
need to be passed.
impb_wac - WAC will be verified first, and then IMPB will be verified. Both authentications
need to be passed.
mac_impb - MAC will be verified first, and then IMPB will be verified. Both authentications
need to be passed.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
The following example sets the authentication mode of all ports to host-based:
DGS-3620-28SC:admin#config authentication ports all auth_mode host_based
Command: config authentication ports all auth_mode host_based
Success.
DGS-3620-28SC:admin#
The following example sets the compound authentication method of all ports to “any”:
DGS-3620-28SC:admin#config authentication ports all multi_authen_methods any
Command: config authentication ports all multi_authen_methods any
Success.
DGS-3620-28SC:admin#
20-6 show authentication
Description
This command is used to display the global authentication configuration.
Format
show authentication
Parameters
None.
Restrictions
None.