D-Link xStack - Delete Syslog Host

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
821
local1 - User-defined facility.
local2 - User-defined facility.
local3 - User-defined facility.
local4 - User-defined facility.
local5 - User-defined facility.
local6 - User-defined facility.
local7 - User-defined facility.
udp_port - Specifies the UDP port number.
<udp_port_number> - Enter the UDP port number.
state - The syslog protocol has been used for the transmission of event notification messages
across networks to host. This option enables or disables the host to receive such messages.
enable - Enable the host to receive messages.
disable - Disable the host to receive messages.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create a new syslog host:
DGS-3620-28SC:admin# create syslog host 1 ipaddress 10.1.1.1
Command: create syslog host 1 ipaddress 10.1.1.1
Success.
DGS-3620-28SC:admin#
71-17 delete syslog host
Description
This command is used to delete syslog host(s).
Format
delete syslog host [<index 1-4> | all]
Parameters
<inex 1-4> - Enter the host index.
all - Specifies all hosts.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To delete a syslog host:
DGS-3620-28SC:admin#delete syslog host 4
Command: delete syslog host 4