D-Link xStack - Chapter 21 Debug Software Command List

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
303
Chapter 21 Debug Software
Command List
debug address_binding [event | dhcp | all] state [enable | disable]
no debug address_binding
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output [module <module_list> | all] [buffer | console]
debug config error_reboot [enable | disable]
debug config state [enable | disable]
debug show error_reboot state
debug stp clear counter {ports [<portlist> | all]}
debug stp config ports [<portlist> | all] [event | bpdu | state_machine | all] state [disable | brief |
detail]
debug stp show counter {ports [<portlist> | all]}
debug stp show flag {ports <portlist>}
debug stp show information
debug stp state [disable | enable]
debug ospf [neighbor_state_change | interface_state_change {dr_bdr_selection} | lsa {all |
originating | installing | receiving | flooding} (1) | packet {all | receiving | sending} (1) |
retransmission | spf {all | intra | inter | extern} (1) | timer | virtual_link | route | redistribution]
state [enable | disable]
debug ospf clear counter {packet | neighbor | spf}
debug ospf log state [enable | disable]
debug ospf show counter {packet | neighbor | spf}
debug ospf show detail external_link
debug ospf show detail net_link
debug ospf show detail rt_link
debug ospf show detail summary_link
debug ospf show detail type7_link
debug ospf show flag
debug ospf show log state
debug ospf show redistribution
debug ospf show request_list
debug ospf show summary_list
debug ospf state [enable | disable]
debug vrrp [vr_state_change | packet [all | {receiving | sending}(1)] | mac_addr_update |
interface_change | timers] state [enable | disable]
debug vrrp clear counter
debug vrrp log state [enable | disable]
debug vrrp show counter
debug vrrp show flag
debug vrrp show log state
debug vrrp state [enable | disable]
debug bgp show flag
debug bgp all flag [enable | disable]
debug bgp fsm_event [enable | disable]
debug bgp packet [{open | update | keepalive | notify | refresh | capability}(1) | all] [in | out]
[enable | disable]
debug bgp error state [enable | disable]
debug bgp show global_info
debug bgp show peer