D-Link xStack - Chapter 95 Spanning Tree Protocol (STP) Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1067
Chapter 95 Spanning Tree
Protocol (STP)
commands
show stp
show stp instance {<value 0-64>}
show stp ports {<portlist>}
show stp mst_config_id
create stp instance_id <value 1-64>
delete stp instance_id <value 1-64>
config stp instance_id <value 1-64> [add_vlan | remove_vlan] <vidlist>
config stp mst_config_id {revision_level <int 0-65535> | name <string>} (1)
enable stp
disable stp
config stp version [mstp | rstp | stp]
config stp priority <value 0-61440> instance_id <value 0-64>
config stp {maxage <value 6-40> | maxhops <value 6-40> | hellotime <value 1-2> | forwarddelay
<value 4-30> | txholdcount <value 1-10> | fbpdu [enable | disable] | nni_bpdu_addr [dot1d |
dot1ad]}(1)
config stp ports <portlist> {externalCost [auto | <value 1-200000000>] | hellotime <value 1-2> |
migrate [yes | no] | edge [true | false | auto] | p2p [true | false | auto] | state [enable | disable] |
restricted_role [true | false] | restricted_tcn [true | false] | fbpdu [enable | disable]} (1)
config stp mst_ports <portlist> instance_id <value 0-64> {internalCost [auto | <value 1-
200000000>] | priority <value 0-240>}(1)
config stp trap {topo_change [disable | enable] | new_root [enable | disable]}
95-1 show stp
Description
This command is used to display the bridge parameters global settings.
Format
show stp
Parameters
None.
Restrictions
None.
Example
To display STP: