D-Link xStack - Debug Stp State

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
316
Message Age : 0
Max Age : 20
Forward Delay : 15
Hello Time : 2
Instance 1:
Port 1 :
Regional Root Bridge : 0 /00-00-00-00-00-00
Internal Root Cost : 0
Designated Bridge : 0 /00-00-00-00-00-00
Designated Port : 0
Remaining Hops : 20
DGS-3620-28SC:admin#
21-14 debug stp state
Description
This command is used to enable or disable the STP debug state.
Format
debug stp state [enable | disable]
Parameters
state - Specifies the STP debug state.
enable - Enable the STP debug state.
disable - Disable the STP debug state.
Restrictions
Only Administrator level users can issue this command.
Example
To configure the STP debug state to enable, and then disable the STP debug state:
DGS-3620-28SC:admin# debug stp state enable
Command: debug stp state enable
Success.
DGS-3620-28SC:admin# debug stp state disable
Command: debug stp state disable
Success.
DGS-3620-28SC:admin#