D-Link xStack - Show Cfm Port

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
252
characters.
ma_index - Specifies the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must be between 1 and 4294967295.
Restrictions
None. (EI Mode Only Command)
Example
To display the MEPs that have faults:
DGS-3620-28SC:admin#show cfm fault
Command: show cfm fault
MD Name MA Name MEPID Status AIS Status LCK Status
----------- ----------- ----- ---------------------- ------------ ------------
op_domain op1 1 Error CCM Received Normal Normal
DGS-3620-28SC:admin#
16-16 show cfm port
Description
This command is used to display MEPs and MIPs created on a port.
Format
show cfm port <port> {level <int 0-7> | direction [inward | outward] | vlanid <vlanid 1-4094>}
Parameters
<port> - Enter the port number.
level - (Optional) Specify the maintenance domain level. If not specified, all levels are shown.
<int 0-7> - Enter the value between 0 and 7.
direction - (Optional) Specify the MEP direction.
inward - Specifies inward facing MEP.
outward - Specifies outward facing MEP.
vlanid - (Optional) Specify the VLAN identifier. If not specified, all VLANs are displayed.
<vlanid 1-4094> - Enter the VLAN ID between 1 and 4094.
Restrictions
None. (EI Mode Only Command)
Example
To display a CFM port:
DGS-3620-28SC:admin#show cfm port 1
Command: show cfm port 1