D-Link xStack - Disable Vrrp

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1178
111-2 disable vrrp
Description
This command is used to disable VRRP globally.
Format
disable vrrp {ping}
Parameters
ping - (Optional) Specifies that the ping option will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable VRRP:
DGS-3620-28SC:admin# disable vrrp
Command: disable vrrp
Success.
DGS-3620-28SC:admin#
111-3 create vrrp vrid
Description
This command is used to create a virtual router entry by VRID.
Format
create vrrp vrid <vrid 1-255> ipif <ipif_name 12> ipaddress <ipaddr> {state [enable | disable]
| priority <int 1-254> | advertisement_interval <int 1-255> | preempt [true | false] | critical_ip
<ipaddr> | critical_ip_state [enable | disable]}
Parameters
vrid - Specifies the ID of the Virtual Router used.
<vrid 1-255> - Enter the Virtual Router ID used here. This value must be between 1 and 255.
ipif - Specifies the IP interface used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
ipaddress - Specifies the virtual router’s IP address used.
<ipaddr> - Enter the virtual router's IP address used here.
state - (Optional) Specifies the state of the virtual router function.
enable - Specifies that the virtual router function will be enabled.
disable - Specifies that the virtual router function will be disabled.