D-Link xStack - Enable Ssh

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1085
Format
config ssh server {maxsession <int 1-8> | contimeout <sec 30-600> | authfail <int 2-20> |
rekey [10min | 30min | 60min | never] | port <tcp_port_number 1-65535>}(1)
Parameters
maxsession - Specifies the SSH server maximum session at the same time.
<int 1-8> - Enter the SSH server maximum session at the same time. The maximum session
value must be between 1 and 8. The default value is 8.
contimeout - Specifies the SSH server connection timeout.
<sec 30-600> - Enter the SSH server connection timeout. The connection timeout value must
be between 30 and 600 seconds. The default value is 120 seconds.
authfail - Specifies the user maximum fail attempts.
<int 2-20> - Enter the user maximum fail attempts. The maximum authentication fail attempts
must be between 2 and 20. The default value is 2.
rekey - (Optional) Specify the time to re-generate the session key.
10min - Specifies 10 minutes to re-generate the session key.
30min - Specifies 30 minutes to re-generate the session key.
60min - Specifies 60 minutes to re-generate the session key.
never - Do not re-generate the session key.
port - Specifies a TCP port number between 1 and 65535.
<tcp_port_number 1-65535> - Enter a TCP port number between 1 and 65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an SSH server maximum session of 3:
DGS-3620-28SC:admin#config ssh server maxsession 3
Command: config ssh server maxsession 3
Success.
DGS-3620-28SC:admin#
96-8 enable ssh
Description
This command is used to enable SSH server services.
Format
enable ssh
Parameters
None.