D-Link xStack - Disable Snmp Traps

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
799
DGS-3620-28SC:admin#enable snmp traps
Command: enable snmp traps
Success.
DGS-3620-28SC:admin#
70-12 disable snmp traps
Description
This command is used to disable SNMP trap support on the switch.
Format
disable snmp traps
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To prevent SNMP traps from being sent from the switch:
DGS-3620-28SC:admin#disable snmp traps
Command: disable snmp traps
Success.
DGS-3620-28SC:admin#
70-13 enable snmp authenticate_traps
Description
This command is used to enable SNMP authentication failure trap support.
Format
enable snmp authenticate_traps
Parameters
None.