D-Link xStack - Config Access_Profile [Profile_Id <Value 1-6> | Profile_Name <Name 1-32>]

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
102
DGS-3620-28SC:admin#
DGS-3620-28SC:admin#create access_profile profile_id 2 profile_name 2 ip vlan
source_ip_mask 255.255.255.255 destination_ip_mask 255.255.255.0 dscp icmp
Command: create access_profile profile_id 2 profile_name 2 ip vlan
source_ip_mask 255.255.255.255 destination_ip_mask 255.255.255.0 dscp icmp
Success.
DGS-3620-28SC:admin#
5-2 delete access_profile
Description
This command is used to delete access list profiles.
Format
delete access_profile [profile_id <value 1-6> | profile_name <name 1-32> | all]
Parameters
profile_id - Specifies the index of the access list profile.
<value 1-6> - Enter the index of the access list profile. Enter a value between 1 and 6.
profile_name - Specifies the profile name.
<name 1-32> - Enter the profile name. The maximum length is 32 characters.
all - Specifies the whole access list profile to delete.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete access list profiles:
DGS-3620-28SC:admin#delete access_profile profile_id 1
Command: delete access_profile profile_id 1
Success.
DGS-3620-28SC:admin#
5-3 config access_profile
Description
This command is used to configure access list entries.
Note: Please see the “Error! Reference source not found. Error! Reference source
not found.” section for a configuration example and further information.