D-Link xStack - Config Wac User; Show Wac

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1223
115-12 config wac user
Description
This command is used to change the VLAN associated with a user.
Format
config wac user <username 15> [vlan <vlan_name 32> | vlanid <vlanid 1-4094> | clear_vlan]
Parameters
<username 15> - Enter the name of user account which will change its VID.
vlan - Specifies the authentication VLAN name.
<vlan_name 32> - Enter the authentication VLAN name. The VLAN name can be up to 32
characters long.
vlanid - Specifies the authentication VLAN ID.
<vlanid 1-4094> - Enter the authentication VLAN ID. The VLAN ID must be between 1 and
4094.
clear_vlan - Specifies to clear the specified VLAN.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the user’s VLAN:
DGS-3620-28SC:admin# config wac user abc vlanid 100
Command: config wac user abc vlanid 100
Enter a old password:**
Enter a case-sensitive new password:**
Enter the new password again for confirmation:**
Success.
DGS-3620-28SC:admin#
115-13 show wac
Description
This command is used to display the WAC global setting.
Format
show wac
Parameters
None.