D-Link xStack - Chapter 51 Japanese Web-Based Access Control (JWAC) Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
631
Chapter 51 Japanese Web-
based Access Control
(JWAC) Commands
enable jwac
disable jwac
enable jwac redirect
disable jwac redirect
enable jwac forcible_logout
disable jwac forcible_logout
enable jwac udp_filtering
disable jwac udp_filtering
enable jwac quarantine_server_monitor
disable jwac quarantine_server_monitor
config jwac quarantine_server_error_timeout <sec 5-300>
config jwac [quarantine_server_url <string 128> | clear_quarantine_server_url]
config jwac redirect {destination [quarantine_server | jwac_login_page] | delay_time <sec 0-
10>}(1)
config jwac virtual_ip <ipaddr> {url [<string 128> | clear]}
config jwac update_server [add | delete] ipaddress <network_address> {[tcp_port <port_number
1-65535> | udp_port <port_number 1-65535>]}
config jwac switch_http_port <tcp_port_number 1-65535> {[http | https]}
config jwac ports [<portlist> | all] {state [enable | disable] | max_authenticating_host <value 0-
100> | aging_time [infinite | <min 1-1440>] | idle_time [infinite | <min 1-1440>] | block_time
[<sec 0-300>]}(1)
config jwac radius_protocol [local | eap_md5 | pap | chap | ms_chap | ms_chapv2]
create jwac user <username 15> {vlan <vlanid 1-4094>}
config jwac user <username 15> {vlan <vlanid 1-4094>}
delete jwac [user <username 15> | all_users]
show jwac user
show jwac
show jwac auth_state ports {<portlist>}
show jwac update_server
show jwac ports {<portlist>}
clear jwac auth_state [ports [all | <portlist>] {authenticated | authenticating | blocked} | mac_addr
<macaddr>]
config jwac authenticate_page [japanese | english]
show jwac authenticate_page
config jwac authentication_page element [japanese | english] [default | page_title <desc 128> |
login_window_title <desc 32> | user_name_title <desc 16> | password_title <desc 16> |
logout_window_title <desc 32> | notification_line <value 1-5> <desc 128>]
config jwac authorization attributes {radius [enable | disable] | local [enable | disable]}(1)
51-1 enable jwac
Description
This command is used to enable the Japanese Web-based access control (JWAC) function. JWAC
and WAC are mutually exclusive functions. That is, they can not be enabled at the same time.