D-Link xStack - Chapter 108 UDP Helper Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1140
Chapter 108 UDP Helper
Commands
enable udp_helper
disable udp_helper
config udp_helper add ipif <ipif_name 12> <ipaddr>
config udp_helper delete ipif <ipif_name 12> <ipaddr>
config udp_helper udp_port add [time | tacacs | dns | tftp | netbios-ns | netbios-ds |
<port_number 0-65535>]
config udp_helper udp_port delete [time | tacacs | dns | tftp | netbios-ns | netbios-ds |
<port_number 0-65535>]
show udp_helper {[udp_port | ipif <ipif_name 12>]}
108-1 enable udp_helper
Description
This command is used to enable the UDP Helper function on the Switch.
Format
enable udp_helper
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the UDP Helper function:
DGS-3620-28SC:admin# enable udp_helper
Command: enable udp_helper
Success.
DGS-3620-28SC:admin#
108-2 disable udp_helper
Description
This command is used to disable the UDP Helper function on the Switch.