xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1075
95-11 config stp version
Description
This command is used to change STP version. If the version is configured as STP or RSTP, all
currently running MSTIs should be disabled. If the version is configured as MSTP, the current chip
design is enabled for all available MSTIs (assuming that CIST is enabled).
Format
config stp version [mstp | rstp | stp]
Parameters
mstp - Specifies to use Multiple Spanning Tree Protocol.
rstp - Specifies to use Rapid Spanning Tree Protocol. This is the default.
stp - Specifies to use Spanning Tree Protocol.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the STP version:
DGS-3620-28SC:admin#config stp version mstp
Command: config stp version mstp
Success.
To configure the STP version with the same value of the old configuration:
DGS-3620-28SC:admin#config stp version mstp
Command: config stp version mstp
Configure value is the same with current value.
Success.
95-12 config stp priority
Description
One of the parameters used to select the Root Bridge.
Format
config stp priority <value 0-61440> instance_id <value 0-64>
To Next Page
Loading...
Need help?
General