D-Link xStack - Config Rmon Trap

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
806
Parameters
None.
Restrictions
None.
Example
To display the trap source IP interface:
DGS-3620-28SC:admin#show trap source_ipif
Command: show trap source_ipif
Trap Source IP Interface Configuration:
IP Interface : ipif4
IPv4 Address : None
IPv6 Address : 3000::52
DGS-3620-28SC:admin#
70-23 config rmon trap
Description
This command is used to configure the trap state for RMON events.
Format
config rmon trap {rising_alarm [enable | disable] | falling_alarm [enable | disable]}
Parameters
rising_alarm - (Optional) Specify the trap state for rising alarm. The default state is enabled.
enable - Enable the trap state for rising alarm.
disable - Disable the trap state for rising alarm.
falling_alarm - (Optional) Specify the trap state for falling alarm. The default state is enabled.
enable - Enable the trap state for falling alarm.
disable - Disable the trap state for falling alarm.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable the trap state for RMON:
DGS-3620-28SC:admin#config rmon trap rising_alarm disable
Command: config rmon trap rising_alarm disable