D-Link xStack - Enable Syslog

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
817
Parameters
time_interval - Specifies to save log to Flash every xxx minutes. If no log occurs in this period,
nothing will be saved.
<min 1-65535> - Enter the time between 1 and 65535 minutes.
on_demand - Specifies to save log to Flash whenever the user types "save log" or "save all".
This is the default.
log_trigger - Specifies to save log to Flash whenever log arrives.
Restrictions
Only Administrator and Operator-level users can issue this command..
Example
To configure method to save log as on demand:
DGS-3620-28SC:admin# config log_save_timing on_demand
Command: config log_save_timing on_demand
Success.
DGS-3620-28SC:admin#
71-12 enable syslog
Description
This command is used to globally enable syslog to send log messages to a remote server.
Format
enable syslog
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable syslog to send a message:
DGS-3620-28SC:admin#enable syslog
Command: enable syslog
Success
DGS-3620-28SC:admin#