D-Link xStack - Chapter 78 PIM6-SM Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
905
Chapter 78 PIM6-SM Commands
config pim6 [ipif <ipif_name 12> | all] {hello_interval <sec 0-18000> | triggered_hello_delay <sec
0-60> | propagation_delay <sec 0-32> | override_interval <sec 0-65> | jp_interval <sec 0-
18000> | dr_priority <uint 0-4294967294> | bsr_border [disable | enable] | stub_interface
[disable | enable] | state [enable | disable]} (1)
show pim6 {ipif <ipif_name 12>}
config pim6 cbsr {ipif <ipif_name 12> state [enable | disable] | priority <value 0-255> |
hash_masklen <value 0-128>} (1)
show pim6 cbsr
config pim6 crp [rp <ipif_name 12> | all] {priority <value 0-255> | interval <sec 1-16383>} (1)
create pim6 crp group <ipv6networkaddr> rp <ipif_name 12>
delete pim6 crp group <ipv6networkaddr>
enable pim6
disable pim6
config pim6 last_hop_spt_switchover [never | immediately]
show pim6 neighbor {ipif <ipif_name 12>}
show pim6 mroute {group <ipv6addr> {source <ipv6addr>}}
create pim6 static_rp group <ipv6networkaddr> rp <ipv6addr> {override_dynamic}
delete pim6 static_rp group <ipv6networkaddr>
config pim6 embedded_rp state [enable | disable]
show pim6 crp
show pim6 static_rp
show pim6 rpset
config pim6 register_checksum_calculate [include_data | not_include_data]
config pim6 register_probe_time <sec 1-127>
config pim6 register_suppression_time <sec 3-65535>
config pim6 keepalive_period <sec 120-65535>
show pim6 mroute s_g {rpt} {group <ipv6addr> source <ipv6addr> {ipif <ipif_name 12>}}
show pim6 mroute star_g {group <ipv6addr> {ipif <ipif_name 12>}}
78-1 config pim6
Description
This command is used to set the PIM6 multicast protocol state and some related parameters in the
protocol on some interface.
Format
config pim6 [ipif <ipif_name 12> | all] {hello_interval <sec 0-18000> | triggered_hello_delay
<sec 0-60> | propagation_delay <sec 0-32> | override_interval <sec 0-65> | jp_interval <sec
0-18000> | dr_priority <uint 0-4294967294> | bsr_border [disable | enable] | stub_interface
[disable | enable] | state [enable | disable]} (1)
Parameters
ipif - Specifies the IP interface used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all - Specifies that all the IP interfaces will be used.
hello_interval - (Optional) Specifies the time between transmits hello packets to find neighboring