D-Link xStack - Enable Stp

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1073
Success.
DGS-3620-28SC:admin#
95-8 config stp mst_config_id
Description
This command is used to configure a configuration name or revision level in the MST configuration
identification. The default configuration name is the MAC address of the bridge.
Format
config stp mst_config_id {revision_level <int 0-65535> | name <string>} (1)
Parameters
revision_level - Specifies the revision level.
<int 0-65535> - Enter the revision level.
name - Specifies the name given for a specified MST region.
<string> - Enter the name given for a specified MST region.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To change the name and revision level of the MST configuration identification:
DGS-3620-28SC:admin#config stp mst_config_id revision_level 1 name R&D_BlockG
Commands: config stp mst_config_id revision_level 1 name R&D_BlockG
Success.
DGS-3620-28SC:admin#
95-9 enable stp
Description
Although it is possible to modify to allow a user to enable STP per instance, CIST should be
enabled first before enabling other instances. When a user enables the CIST, all MSTIs will be
enabled automatically if FORCE_VERSION is set to MSTP and there is at least one VLAN
mapped to this instance.
Format
enable stp