D-Link xStack - Page 335

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
330
Example
To display the current OSPF summary list:
DGS-3620-28SC:admin# debug ospf show summary_list
Command: debug ospf show summary_list
OSPF Summary List:
Area 0.0.0.0:
Circuit: 1.1.1.1
Neighbor: 90.2.0.1 IP: 1.1.1.2
LSID: 1.1.1.1 RTID: 1.1.1.1
Circuit: 2.2.2.1
Circuit: 10.1.1.6
DGS-3620-28SC:admin#
21-29 debug ospf state
Description
This command is used to set the OSPF debug global state.
Format
debug ospf state [enable | disable]
Parameters
state - Specifies the OSPF debug global state.
enable - Specifies that the OSPF debug global state will be enabled.
disable - Specifies that the OSPF debug global state will be disabled.
Restrictions
Only Administrator level users can issue this command.
Example
To enable the OSPF debug global state: