D-Link xStack - Page 511

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
506
38-10 move
Description
This command is used to move a file around the file system. Note that when a file is moved, it can
be specified whether to be renamed at the same time.
Format
move {{unit <unit_id>} <drive_id>} <pathname> {{unit <unit_id>} <drive_id>} <pathname>
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Enter the file to be moved. The path name can be specified either as a full path
name or partial name. For a partial path name, it indicates the file is in the current directory.
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Enter the new path where the file will be moved. The path name can be specified
either as a full path name or partial name. For a partial path name, it indicates the file is in the
current directory.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To move a file or directory:
DGS-3620-28SC:admin#move c:/log.txt c:/abc/log1.txt
Command: move c:/log.txt c:/abc/log1.txt
Success.
DGS-3620-28SC:admin#
38-11 copy
Description
This command is used to copy a file to another file in the file system.
Format
copy {{unit <unit_id>} <drive_id>} <pathname> {{unit <unit_id>} <drive_id>} <pathname>