D-Link xStack - Page 168

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
163
Format
config out_band_ipif {ipaddress <network_address> | state [enable | disable] | gateway
<ipaddr>} (1)
Parameters
ipaddress - Specifies the IP address of the interface. The parameter must include the mask.
<network_address> - Enter the IP address of the interface. The parameter must include the
mask.
state – Specify the interface status.
enable - Specifies to enable the interface.
disable - Specifies to disable the interface.
gateway - Specifies the gateway IP address of the out-of-band management network.
<ipaddr> - Enter the gateway IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable the out-of-band management state:
DGS-3620-28SC:admin#config out_band_ipif state disable
Command: config out_band_ipif state disable
Success.
DGS-3620-28SC:admin#
11-8 show out_band_ipif
Description
This command is used to display the current configurations of special out-of-band management
interfaces.
Format
show out_band_ipif
Parameters
None.
Restrictions
None.