xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1030
Command: create sflow flow_sampler ports 1 analyzer_server_id 1 rate 200
maxheadersize 120
Success.
92-5 config sflow flow_sampler ports
Description
This command is used to configure the sFlow flow sampler parameters.
Format
config sflow flo
w_sampler
ports [<portl
ist> | all] {r
ate <value 0
-65535> | tx_rate <value 0-65535> | maxheadersize <value 18-256>}(1)
Parameters
<portlist> - Enter the list of ports to be configured.
all - Specifies to configure all ports.
rate - Specifies the sampling rate for packet sampling.
<value 0-65535> - Enter the sampling rate for packet sampling. The configured rate value
multiplied by 256 is the actual rate. For example, if the rate is 20, the actual rate 5120. One
packet will be sampled from every 5120 packets. If set to 0, the sampler is disabled. If the
rate is not specified, its default value is 0.
tx_rate – Specifies the transmit rate.
<value 0-65535> - Enter the transmit rate used here. This value must be between 0 and
maxheadersize - Specifies the maximum number of leading bytes in the packet which has been
sampled that will be encapsulated and forwarded to the server.
<value 18-256> - Enter the maximum number of leading bytes in the packet which has been
sampled that will be encapsulated and forwarded to the server. If not specified, the default
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the sFlow flow sampler parameters:
DGS-3620-28SC:admin#config sflow flow_sampler ports all rate 1
Command: config sflow flow_sampler ports all rate 1
Success.
To Next Page
Loading...
Need help?
General