D-Link xStack - Page 1047

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1042
Format
reconfig [member_id <value 1-32> | exit]
Parameters
member_id - Specifies the serial number of a member.
<value 1-32> - Enter the serial number of a member. The value is between 1 and 32.
exit - Specifies to terminate command switch access.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To re-Telnet to a member:
DGS-3620-28SC:admin#reconfig member_id 1
Command: reconfig member_id 1
DGS-3620-28SC:admin#
DGS-3620-28SC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.50.014
Copyright(C) 2013 D-Link Corporation. All rights reserved.
DGS-3620-28SC:admin#
93-5 config sim_group
Description
This command is used to configure group information on the switch.
Format
config sim_group [add <candidate_id 1-100> {<password>} | delete <member_id 1-32>]
Parameters
add - Specifies to add a specific candidate to the group.
<candidate_id 1-100> - Enter to add a specific candidate to the group.
<password> - (Optional) Specify the password of a candidate, if necessary.
delete - Specifies to remove a specific member from the group.
<member_id 1-32> - Enter to remove a specific member from the group. The ID is from 1 to
32.
Restrictions
Only Administrator-level users can issue this command.