D-Link xStack - Page 1107

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1102
98-8 config stacking log state
Description
This command is used to configure the log state for stacking.
Format
config stacking log state [enable | disable]
Parameters
enable - Specifies that the Switch’s stacking log will be enabled.
disable - Specifies that the Switch’s stacking log will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the stacking log state:
DGS-3620-28SC:admin#config stacking log state enable
Command: config stacking log state enable
Success.
DGS-3620-28SC:admin#
98-9 config stacking trap state
Description
This command is used to configure the trap state for stacking.
Format
config stacking trap state [enable | disable]
Parameters
enable - Specifies that the Switch’s stacking trap will be enabled.
disable - Specifies that the Switch’s stacking trap will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.