D-Link xStack

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
108
Permit
URPF State Check: Enabled
(Replaced)Priority : 7
Replace ToS Precedence : 7
==============================================================================
==============================================================================
Profile ID: 2 Profile name: IPv4ACL Type: IPv4
Mask on
VLAN : 0xFFF
DSCP
ICMP
Type
Code
Available HW Entries : 254
------------------------------------------------------------------------------
Rule ID : 1 Ports: 1
Match on
VLAN ID : 1
DSCP : 63
ICMP
Type : 255
Code : 255
Action:
Permit
URPF State Check: Enabled
(Replaced)Priority : 7
Replace ToS Precedence : 7
==============================================================================
DGS-3620-28SC:admin#
Note: “Total User Set Entries” indicates the total number of ACL rules created by the
user. “Total Used HW Entries” indicates the total number of hardware entries used
in the device. “Available HW Entries” indicates the total number of available
hardware entries in the device.
To display an access profile that supports an entry mask for each rule:
DGS-3620-28SC:admin#show access_profile profile_id 3
Command: show access_profile profile_id 3
Access Profile Table
==============================================================================
Profile ID: 3 Profile name: IPv6ACL Type: IPv6