D-Link xStack - Page 1173

To Next Page

To Previous Page

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

1168

Parameters

<ipv6addr> - Enter the IPv6 address of the host.

<domain_name 255> - Enter the domain name of the host. This name can be up to 255

characters long.

times - (Optional) Specify the number of individual ICMP echo messages to be sent.

<value 1-255> - Enter the number of individual ICMP echo messages to be sent. A value of 0

will send an infinite ICMP echo messages. The maximum value is 255. The default is 0.

size - (Optional) Specify the size.

<value 1-6000> - Enter the size. A value of 1 to 6000 can be specified. The default is 100.

timeout - (Optional) Specify the time-out period while waiting for a response from the remote

device.

<sec 1-99> - Enter the time-out period while waiting for a response from the remote device. A

value of 1 to 99 can be specified. The default is 1 second.

source_ip - Specifies the source IPv6 address of the ping packets. If specified, the IPv6 address

will be used as the packets’ source IPv6 address that ping send to remote host.

<ipv6addr> - Enter the source IPv6 addres used here.

Restrictions

None.

Example

To send ICMP echo message to “3FFE:2::D04D:7878:66D:E5BC” for 10 times:

DGS-3620-28SC:admin#ping6 3FFE:2::D04D:7878:66D:E5BC times 10 size 6000 timeout

Command: ping6 3FFE:2::D04D:7878:66D:E5BC times 10 size 6000 timeout 10

Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms

Ping Statistics for 3FFE:2::D04D:7878:66D:E5BC

Packets: Sent =10, Received =10, Lost =0

DGS-3620-28SC:admin#

110-18 traceroute

Description

This command is used to trace a route between the switch and a given host on the network.

Other manuals for D-Link xStack