xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1188
DGS-3620-28SC:admin#config voice_vlan ports 4-6 state enable
Command: config voice_vlan ports 4-6 state enable
Success.
To set voice VLAN ports 4 to 6 to auto mode:
DGS-3620-28SC:admin#config voice_vlan ports 4-6 mode auto
Command: config voice_vlan ports 4-6 mode auto
Success.
112-6 config voice_vlan log state
Description
This command is used to configure the voice VLAN log state.
Format
config voice_vlan log state [enable | disable]
Parameters
enable - Specifies to enable the voice VLAN log state.
disable - Specifies to disable the voice VLAN log state.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the voice VLAN log state:
DGS-3620-28SC:admin#config voice_vlan log state enable
Command: config voice_vlan log state enable
Success.
112-7 config voice_vlan aging_time
Description
This command is used to set the aging time of the voice VLAN. The aging time is used to remove
a port from voice VLAN if the port is an automatic VLAN member. When the last voice device
stops sending traffic and the MAC address of this voice device is aged out, the voice VLAN aging
To Next Page
Loading...
Need help?
General