xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1219
DGS-3620-28SC:admin#config wac method radius
Command: config wac method radius
Success.
115-6 config wac default_redirpath
Description
This command is used to configure the WAC default redirect path. If default redirect path is
configured, the user will be redirected to the default redirect path after successful authentication.
When the string is cleared, the client will not be redirected to another URL after successful
authentication.
Format
config wac default_redirpath <string 128>
Parameters
<string 128> - Enter the URL that the client will be redirected to after successful authentication.
By default, the redirected path is cleared.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the WAC default redirect path:
DGS-3620-28SC:admin#config wac default_redirpath http://www.dlink.com
Command: config wac default_redirpath http://www.dlink.com
Success.
115-7 config wac clear_default_redirpath
Description
This command is used to clear the WAC default redirect path. When the string is cleared, the client
will not be redirected to another URL after successful authentication.
Format
config wac clear_default_redirpath
To Next Page
Loading...
Need help?
General