xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
121
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable CPU interface filtering:
DGS-3620-28SC:admin#enable cpu_interface_filtering
Command: enable cpu_interface_filtering
Success.
5-13 disable cpu_interface_filtering
Description
This command is used to disable CPU interface filtering.
Format
disable cpu_interface_filtering
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable CPU interface filtering:
DGS-3620-28SC:admin#disable cpu_interface_filtering
Command: disable cpu_interface_filtering
Success.
5-14 config flow_meter
Description
This command is used to configure the flow-based metering function. The metering function
supports three modes: single rate two color, single rate three color, and two rate three color. The
access rule must be created before the parameters of this function can be applied. For the single
rate two color mode, users may set the preferred bandwidth for this rule, in Kbps, and once the
bandwidth has been exceeded, overflowing packets will either be dropped or remarked DSCP,
To Next Page
Loading...
Need help?
General