D-Link xStack - Page 1263

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1258
JWAC
Event description: When a client host authenticated successful.
Log Message: JWAC authenticated user (Username: <string>, IP:
<ipaddr>, MAC: <macaddr>, Port: <[unitID:]portNum>)
Parameters description:
string: Username
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Informational
Event description: When a client host fails to authenticate.
Log Message: JWAC unauthenticated user (User Name: <string>,
IP: <ipaddr>, MAC: <macaddr>, Port: <[unitID:]portNum>)
Parameters description:
string: User name
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Warning
Event description: This log will be triggered when the number of
authorized users reaches the maximum user limit on the whole
device.
Log Message: JWAC enters stop learning state.
Warning
Event description: This log will be triggered when the number of
authorized users is below the maximum user limit on the whole
device in a time interval (5 min).
Log Message: JWAC recovered from stop learning state.
Warning
LBD
Event Description: Loop back is detected under port-based mode.
Log Message:
Port < [unitID:] portNum> LBD loop occurred. Port blocked.
Parameters Description:
portNum: The port number.
Critical
Event Description: Port recovered from LBD blocked state under
port-based mode.
Log Message:
Port < [unitID:] portNum>LBD port recovered. Loop detection
restarted
Parameters Description:
portNum: The port number.
Informational
Event Description: Loop back is detected under VLAN-based mode.
Log Message:
Port < [unitID:] portNum> VID <vlanID> LBD loop occurred. Packet
discard begun
Parameters Description:
portNum: The port number.
vlanID: the VLAN ID number.
Critical
Event Description: Port recovered from LBD blocked state under
VLAN-based mode.
Log Message:
Port < [unitID:] portNum> VID <vlanID> LBD recovered. Loop
detection restarted
Parameters Description:
portNum: The port number.
vlanID: the VLAN ID number.
Informational
Event Description: The number of VLAN in which loop back occurs
hit the specified number.
Log Message:
Loop VLAN number overflow.
Parameters Description:
None
Informational
IMPB
Event description: Dynamic IMPB entry conflicts with static ARP.
Log Message: Dynamic IMPB entry conflicts with static ARP(IP:
Warning