D-Link xStack - Page 1267

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1262
InstanceID: Instance ID.
Event description: Spanning Tree Version changed.
Log Message: Spanning Tree version changed. New
version:<new_version>
Parameters description:
new_version: New STP version.
Informational
Event description: Spanning Tree MST configuration ID name and
revision level changed.
Log Message: Spanning Tree MST configuration ID name and
revision level changed (name:<name> ,revision level
<revision_level>).
Parameters description:
name : New name.
revision_level:New revision level.
Informational
Event description: Spanning Tree MST configuration ID VLAN
mapping table deleted.
Log Message: Spanning Tree MST configuration ID VLAN mapping
table changed (instance: <InstanceID> delete vlan <startvlanid> [-
<endvlanid>]).
Parameters description:
InstanceID: Instance ID.
startvlanid- endvlanid:VLANlist
Informational
Event description: Spanning Tree MST configuration ID VLAN
mapping table added.
Log Message: Spanning Tree MST configuration ID VLAN mapping
table changed (instance: <InstanceID> add vlan <startvlanid> [-
<endvlanid>]).
Parameters description:
InstanceID: Instance ID.
startvlanid- endvlanid:VLANlist
Informational
CFM
Event description: Cross-connect is detected
Log Message: CFM cross-connect. VLAN:<vlanid>, Local(MD
Level:<mdlevel>, Port <[unitID:]portNum>,
Direction:<mepdirection>) Remote(MEPID:<mepid>,
MAC:<macaddr>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Can be "inward" or "outward".
mepid: Represents the MEPID of the MEP. The value 0 means
unknown MEPID.
macaddr: Represents the MAC address of the MEP. The value all
zeros mean unknown MAC address.
Note: In CFM hardware mode,
remote MEP information (mepid and
macaddr) is unknown.
Critical
Event description: Error CFM CCM packet is detected
Log Message: CFM error ccm. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>) Remote(MEPID:<mepid>,
MAC:<macaddr>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Can be "inward" or "outward".
mepid: Represents the MEPID of the MEP. The value 0 means
unknown MEPID.
macaddr: Represents the MAC address of the MEP. The value all
zeros means unknown MAC address.
Warning