D-Link xStack - Page 130

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
125
5-15 show flow_meter
Description
This command is used to display the flow meter table.
Format
show flow_meter {[profile_id <value 1-6> | profile_name <name 1-32>] {access_id <value 1-
256>}}
Parameters
profile_id - (Optional) Specify the profile ID.
<value 1-6> - Enter the profile ID. Enter a value between 1 and 6.
profile_name - (Optional) Specify the name of the profile.
<name 1-32> - Enter the name of the profile. The maximum length is 32 characters.
access_id - (Optional) Specify the access ID.
<value 1-256> - Enter the access ID. Enter a value between 1 and 256.
Restrictions
None.
Example
To display the flow meter configuration:
DGS-3620-28SC:admin#show flow_meter
Command: show flow_meter
Flow Meter Information
------------------------------------------------------------------------------
Profile ID:1 Aceess ID:1 Mode : trTCM / ColorBlind
CIR(Kbps):1000 CBS(Kbyte):200 PIR(Kbps):2000 PBS(Kbyte):200
Action:
Conform : Permit Counter: Disabled
Exceed : Permit Replace DSCP: 21 Counter: Disabled
Violate : Permit Replace DSCP: 21 Counter: Disabled
------------------------------------------------------------------------------
Total Entries: 1
DGS-3620-28SC:admin#