xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
10
operator - Specifies the name of the operator account.
power_user - Specifies a power user level account. The power user level is lower than the
operator level and higher than the user level.
user - Specifies the name of the user account.
<username 15> - Enter a username of up to 15 characters.
encrypt - Specifies the encryption used.
plain_text - Specifies the password in plain text form.
sha_1 - Specifies the password in SHA-1 encrypted form.
<password> - The password for the user account. The length of a password in plain-text form
and encrypted form are different. For a plain-text form password, the password must be a
minimum of 0 characters and a maximum of 15 characters. For an encrypted form
password, the length is fixed to 35 bytes long. The password is case-sensitive.
Restrictions
Only Administrator-level users can issue this command.
Example
To create the Administrator-level user “dlink”:
DGS-3620-28SC:admin#create account admin dlink
Command: create account admin dlink
Enter a case-sensitive new password:****
Enter the new password again for confirmation:****
Success.
To create the Operator-level user “Sales”:
DGS-3620-28SC:admin##create account operator Sales
Command: create account operator Sales
Enter a case-sensitive new password:****
Enter the new password again for confirmation:****
Success.
To create the User-level user “System”:
DGS-3620-28SC:admin##create account user System
Command: create account user System
Enter a case-sensitive new password:****
Enter the new password again for confirmation:****
Success.
To Next Page
Loading...
