xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
176
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To enable BGP protocol:
13-2 disable bgp
Description
This command is used to disable the BGP protocol. By disabling the BGP protocol, all peers will be
disconnected and dynamic routes will be deleted. All the static configurations however will be
reserved. If BGP enables again, the previous configurations can be re-applied.
Format
disable bgp
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To disable BGP protocol:
To Next Page
Loading...
