D-Link xStack - Page 194

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
189
disable - Specifies that the BGP dampening function's state will be disabled.
half_life - (Optional) Specifies the time (in minute) after which the penalty of the reachable routes
will be down, by half. The default setting is 15 minutes.
<value 1-45> - Enter the half life value here. This value must be between 1 and 45 minutes.
reuse - (Optional) If the penalty for a flapping route decreases enough to fall below this value, the
route is unsuppressed. The default setting is 750.
<value 1-20000> - Enter the re-use value used here. This value must be between 1 and
20000.
suppress - (Optional) A route is suppressed when its penalty exceeds this limit. The default
setting is 2000.
<value 1-20000> - Enter the surpress value used here. This value must be between 1 and
20000.
max_suppress_time - (Optional) Maximum time (in minutes) a route can be suppressed. The
default setting is 45 minutes.
<min 1-255> - Enter the maximum suppress time value here. This value must be between 1
and 255 minutes.
un_reachablity_half_life - (Optional) Specifies the time (in minute) after which the penalty of the
unreachable routes will be down, by half. The default setting is 15 minutes.
<value 1-45> - Enter the the time after which the penalty of the unreachable routes will be
down, by half here. This value must be between 1 and 45 minutes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This command shows how to disable the dampening function:
DGS-3620-28SC:admin# config bgp dampening state disable
Command: config bgp dampening state disable
Success.
DGS-3620-28SC:admin# show bgp dampening
Command: show bgp dampening
BGP Dampening State :Enabled
BGP Dampening Route_Map :dmp1
Half-life Time :15 mins
Reuse Value :500
Suppress Value :900
MAX Suppress Time :60 mins
Unreachable route's Half-life :15 mins
DGS-3620-28SC:admin# show bgp route
Command: show bgp route
BGP Local Router ID is 20.90.90.90
Status codes: s suppressed, d damped, h history, * valid, > best, i - internal
Origin codes: i - IGP, e - EGP, ? - incomplete