D-Link xStack - Page 202

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
197
characters long.
ebgp_multihop - (Optional) Specifies the TTL of BGP packet sent to the neighbor. For an EBGP
neighbor the default setting is 1. This means only direct connected neighbors are allowed.
<value 1-255> - Enter the EBGP multi-hop value used here. This value must be between 1
and 255.
weight - (Optional) The valid range is from 0 to 65535. If this is not specified, the routes learned
through another BGP peer will have a default weight of 0. Routes sourced by the local router
have a weight of 32768. It cannot be changed.
value <0-65535> - Enter the weight value used here. This value must be between 0 and
65535.
default - Specifies that the default weight value will be used.
update_source - (Optional) Specifies an interface to be used by BGP sessions for the TCP
connection. By default, this parameter is not set.
add - Specifies to add an interface.
delete - Specifies to delete an interface.
ipif - (Optional) Specifies the IP interface name used.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
send_community - (Optional) This specifies the communities attribute to be sent to the BGP
neighbor.
standard - Only standard communities will be sent.
none - No communities will be sent. The default value is none.
next_hop_self - (Optional) Enable or disable the next hop self attribute. By default, this setting is
disabled.
enable - Specifies that the next-hop-self attribute will be enabled.
disable - Specifies that the next-hop-self attribute will be disabled.
soft_reconfiguration_inbound - (Optional) Specifies to enable or disable the inbound soft
reconfiguration function. By default, this setting is disabled.
enable - Specifies that the soft re-configuration inbound option will be enabled.
disable - Specifies that the soft re-configuration inbound option will be disabled.
remove_private_as - (Optional) If this setting is set to enable, the private AS number in the AS
path attribute of the BGP update packets will be dropped. By default, the setting is disabled.
enable - Specifies that the 'remove private AS' option will be enabled.
disable - Specifies that the 'remove private AS' option will be disabled.
allowas_in - (Optional) If the allow_as setting is enabled, the BGP router’s self AS is allowed in
the AS path list. By default, the allow_as setting is disabled. If no number is supplied, the
default value of 3 times is used.
enable - Specifies that the allow AS-in option will be enabled.
<value 1-10> - Enter the allow AS-in value used here. This value must be between 1 and 10.
disable - Specifies that the allow AS-in option will be disabled.
default_originate - (Optional) Specifies to enable or disable the default originate function. By
default, this setting is disabled.
enable - Specifies that the default originate function will be enabled.
route_map - Specifies the route map name.
<map_name 16> - Enter the route map name here. This name can be up to 16
characters long.
disable - Specifies that the default originate function will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example shows how to configure the EBGP multi-hop to 2: