D-Link xStack - Page 206

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
201
out - Specifies the outgoing routes sent to the peer.
add - Specifies that a route map will be added.
delete - Specifies that a route map will be deleted.
<map_name 16> - Enter the unsurpress map name here. This name can be up to 16
characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example shows how to configure the unsuppress map of peer group “Campus” to Profile1:
DGS-3620-28SC:admin# config bgp neighbor map peer_group Campus unsuppress_map
add Profile1
Command: config bgp neighbor map peer_group Campus unsuppress_map add Profile1
Success.
DGS-3620-28SC:admin#
13-28 config bgp neighbor filter
Description
The command is used to configure the filter related setting for a BGP neighbor.
filter_list: If the filter_list doesn’t exist or does exist but have no filter entry, it means deny any.
prefix_list: If the prefix_list doesn’t exist, it means deny any. If the prefix_list does exist but have
no filter entry defined, it will permit all.
capability_orf_prefix_list: BGP Outbound Route Filter Capability allows one BGP router to install
its configured inbound prefix_list filter on to the remote BGP router. This is used for reducing the
amount of unwanted routing updates from the remote peer.
Format
config bgp neighbor filter [<ipaddr> | peer_group <peer_group_name 16>] {filter_list [in |
out] [add | delete] <list_name 16> | prefix_list [in | out] [add | delete] <list_name 16> |
capability_orf_prefix_list [receive | send | both | none]}(1)
Parameters
<ipaddr> - Specifies the IP address of the neighbor to be configured.
peer_group- Specifies the peer group to be configured.
<peer_group_name 16> - Enter the peer group name here. This name can be up to 16
characters long.
filter_list - (Optional) Specifies the name of an as_path access_list to be applied as a filter. The
filtering can be applied to incoming routes or outgoing routes.
in - Specifies that the filter specified will be used for incoming traffic.
out - Specifies that the filter specified will be used for outgoing traffic.